The new membrane-label easy-click, snap-dome power button on select Industrial Sensors features multiple functions with red and green LED status indicators. The new button is waterproof and is rated UV-stable for indoor and outdoor use. The LED indicator signals: Power and status—The device’s power state (on/off) and button state (pressed/not pressed). Communication viability—The LED will […]
Category Archives: Installation
Motion Sensor Installation Guide
Sensor Overview Motion & Occupancy The Motion Detection Sensor detects motion and movement using a passive infrared (PIR) motion sensing element. The element detects relative changes in temperature caused by people or animals moving through the viewing area. Once the sensor detects movement, it communicates with the Online Sensor Monitoring and Notification System. The cloud […]
Water Detection Puck Installation Guide
Sensor Overview The Wireless Water Detection Puck Sensor detects when water is present by completing the circuit between the two probe points (exposed stainless steel metal screw heads) on the bottom of the sensor. When the detection state changes (water present or absent), the Water Puck Sensor will immediately turn on the radio and transmit […]
Wireless Humidity Sensor Installation
This tech-tip is meant to give to give some suggestions for installing wireless humidity sensors for your application. Mounting Your Sensor Before mounting your sensor, check to make sure the sensors has been added to your viewmysensors account. Sensors must be registered to a gateway to be operable. To register 1. Open ViewMySensors from […]
Wireless Open-Closed Sensor Installation
This tech-tip is meant to give some suggestions for installing wireless open-closed sensors for your application. Before Mounting Your Sensor Before mounting your sensor, check to make sure the sensors has been added to your viewmysensors account. Sensors must be registered to a gateway to be operable. To register 1. Open ViewMySensors from a […]
Wireless Motion Sensor Installation
This tech-tip is meant to give some suggestions for installing wireless motion sensors for your application. Before Mounting Your Sensor Before mounting your sensor, make sure that the sensor has been added to your ViewMySensors account. Sensors must be registered to a gateway to be operable. If the sensor (s) have not been added, […]
Replacing Batteries in Your Wireless Sensors
How to replace the batteries in your wireless sensors. Our standard sensors with AA battery, simply slide the battery compartment door open to access the batteries. With our standard sensors, once the coin cell battery has been depleted, you can change the battery by peeling the sticker away from the battery slot, then from the […]
Wireless Temperature Installation For Coolers
This tech-tip is meant to give to give some suggestions for installing wireless sensors for applications involving walk-in coolers or freezers. The MSG O3A wireless sensors communicate via RF (radio frequency) and it is important to note that the metal construction of most coolers and freezers can interfere with radio signal. It is also important […]